The 2013 Toyota Sequoia is offered in a gasoline model. After performing an oil change the maintenance data will need to be reset. Follow these steps to reset this light:
1. Turn the ignition to run (one position before starting engine).
2. Ensure Trip Metre A reading is shown. Turn the ignition off.
3. While holding down the trip meter reset knob turn the ignition to run (one position before starting engine).
Without multi-information display
4. Continue to press and hold the button until the trip meter displays “000000”.
With multi-information display
4. Continue to press and hold the button until “MAINT REQD RESET MODE COMPLETE” appears on the multi-information display.
5. Turn the ignition off and then start the engine to verify the indicator has been reset.
When doing the oil change and topping up fluids you will need to use the following specifications:
Engine Size | 8 Cyl. 5.7L Gas |
Motor Oil | 0W20 |
Oil Capacity w/Filter | 7.9 US qt. (7.5L) |
Brake Fluid | Dot 3 |
Engine Coolant | Toyota Super Long Life Coolant |
Automatic Transmission | Toyota Genuine ATF WS |
Front Differential | Toyota Genuine Differential gear oil LT75W-85 GL-5 or equivalent |
Rear Differential | Toyota Genuine Differential gear oil LT75W-85 GL-5 or equivalent |
Transfer Case | SAE 75W90 |
You can cross reference the following Purolator filter numbers for your own application:
Engine Size | 8 Cyl. 5.7L Gas |
Oil Filter | L25702 |
Air Filter | A55799 |
Cabin Filter | C35667 |