The 2013 Toyota Tacoma is offered in a gasoline model. After performing the oil change the maintenance data will need to be reset. Follow these steps to reset this light:
1. Turn the ignition to run (one position before starting engine).
2. Ensure trip meter A reading is shown. Turn ignition off.
3. While holding down the trip meter reset knob turn the ignition to run (one position before starting engine).
4. Hold down knob for at least 5 seconds. The odometer indicates “000000” and the light goes off. If the system fails to reset, the light will continue flashing.
5. Turn the ignition off and then start the engine to verify the indicator has been reset.
When doing the oil change and topping up fluids you will need to use the following specifications:
Engine Size | 4 Cyl. 2.7L Gas | 6 Cyl. 4.0L Gas |
Motor Oil | 0W20 | 5W30 |
Oil Capacity w/Filter | 6.1 US qt. (5.8L) | 2WD4.8 US qt. (4.5L)4WD5.5 US qt. (5.2L) |
Brake/Clutch Fluid | Dot 3 | Dot 3 |
Engine Coolant | Toyota Super Long Life Coolant | Toyota Super Long Life Coolant |
Power Steering Fluid | ATF DEXRON II or III | ATF DEXRON II or III |
Automatic Transmission | 4 Speed ModelToyota Genuine ATF Type T-IV5 Speed ModelToyota Genuine ATF WS | 4 Speed ModelToyota Genuine ATF Type T-IV5 Speed ModelToyota Genuine ATF WS |
Manual Transmission | SAE 75W90 | SAE 75W90 |
Front Differential | Toyota Genuine Differential gear oil LT75W-85 GL-5 or equivalent | Toyota Genuine Differential gear oil LT75W-85 GL-5 or equivalent |
Rear Differential | Toyota Genuine Differential gear oil LT75W-85 GL-5 or equivalent | Toyota Genuine Differential gear oil LT75W-85 GL-5 or equivalent |
Transfer Case | SAE 75W90 | SAE 75W90 |
You can cross reference the following Purolator filter numbers for your own application:
Engine Size | 4 Cyl. 2.7L Gas | 6 Cyl. 4.0L Gas |
Oil Filter | L10241 | L10241 |
Air Filter | A35625 | A35578 |
Cabin Filter | C35644 | C35644 |
Always consult the owner’s manual or manufacturer prior to any service
