Tired of ads? Remove them as a Premium Member. Read more

2009 NISSAN Cube Maintenance Light Reset Instructions

Instructions Add comments

1. Turn the ignition to run (one position before starting engine). The maintenance information (the wrench symbol and distance to change a maintenance item) comes on for about 5 seconds and then turns off.
2. Push the trip button and hold for 3 seconds while the wrench symbol and maintenance information are
are displayed. The symbol and distance display will start flashing and the display shows the current interval (ie. 5000KM).
3. Push the trip button to increase the interval distance. Each step increases the interval by 1000km. The interval distance can be set up to 30000km after the display returns to 0.
4. If no further action is made, the display returns to the previous mode and the new interval is set. If the interval distance is set to 0, the display will skip the maintenance information when the ignition is placed in run or start mode.
5. Turn the ignition off and then start the engine to verify the indicator has been reset.

Comments are closed.


Remove ads as a Premium Member. Read More