
The 2013 Toyota RAV4 is offered in a gasoline model. After performing the oil change the maintenance data will need to be reset. Follow these steps to reset this light:
Vehicles without a smart key system
1. Switch the display to the trip meter A and then turn the engine switch to the “LOCK” position.
2. While pressing the “DISP” button, turn the engine switch to the“ON” position (do not start the engine).
3. Continue to press and hold the button until the trip meter displays “000000”.
4. Start the engine and verify the indicator has been reset.
Vehicles with a smart key system
1. Switch the display to the trip meter A and then turn the engine switch off.
2. While pressing the “DISP” button, turn the engine switch to IGNITIONON mode (do not start the engine).
3. Continue to press and hold the button until the trip meter displays “000000”.
4. Start the engine and verify the indicator has been reset.
When doing the oil change and topping up fluids you will need to use the following specifications:
Engine Size | 4 Cyl. 2.5L Gas |
Motor Oil | 0W20 |
Oil Capacity w/Filter | 4.6 US qt. (4.4L) |
Brake Fluid | Dot 3 |
Engine Coolant | Toyota Super Long Life Coolant |
Automatic Transmission | Toyota Genuine ATF WS |
Rear Differential | Toyota Genuine Differential gear oil LT75W-85 GL-5 or equivalent |
Transfer Case | Toyota Genuine Differential gear oil LT75W-85 GL-5 or equivalent |
You can cross reference the following Purolator filter numbers for your own application:
Engine Size | 4 Cyl. 2.5L Gas |
Oil Filter | L25608 |
Air Filter | A25786 |
Cabin Filter | *Dealer Part |