Tired of ads? Remove them as a Premium Member. Read more

2013 Toyota 4Runner “MAINT REQD” Reset & Service Specifications

How To Fridays Add comments

2013 4Runner

For the 2013 Toyota 4Runner, after performing an oil change the MAINT REQD light can be reset by doing the following:

Switch the display to the trip meter A when the engine is running.

Vehicles without a smart key system

Turn the engine switch off.

Vehicles with a smart key system

Turn the “ENGINE START STOP” switch off.

Vehicles without a smart key system

While pressing the trip meter reset button , turn the engine switch to the “ON” position (do not start the engine because reset mode will be canceled). Continue to press and hold the button until the trip meter displays “000000”.

Vehicles with a smart key system

While pressing the trip meter reset button, turn the “ENGINE START STOP” switch to the IGNITION ON mode (do not start the engine because otherwise the reset mode will be can- celed). Continue to press and hold the button until the trip meter displays “000000”.

This vehicle recommends the following fluids:

  1. Engine Oil - 0W20 (6.2L of oil with filter)

  2. Automatic Transmission  - Toyota Genuine ATF WS

  3. Differential (Front/Rear) - 75W-85 GL5

    4Runner Engine

  4. Transfer Case - SAE 75W

  5. Coolant - Toyota Super Long Life

  6. Brake Fluid - Dot 3

  7. Power Steering - ATF Dexron II or III

  8. Tire Pressure (front/rear/spare) - 32 p.si. cold

You can cross reference the following Purolator Filter numbers:

  1. Air Filter - A36122

  2. Oil Filter - L25609

  3. Cabin Filter - C35667

With this information, you should be well on your way to servicing the 2013 Toyota 4Runner.

One Response to “2013 Toyota 4Runner “MAINT REQD” Reset & Service Specifications”

  1. Mark Says:

    I’m sorry to bother you and sound like an idiot but where is the oil filter located on a 2013 4runnerSR5. pleasehelp


Remove ads as a Premium Member. Read More