The 2015 Toyota Corolla is equipped with the Toyota Maintenance Data System. After performing the oil change, the oil change indicator will need to be reset. The reset can be performed by following these instructions:
1. Press the “ENGINE START STOP” switch once (do not start engine) or turn ignition key to run (one position before starting engine).
2. Ensure Trip Metre A reading is shown (use the Trip button for vehicles with a Multi-Information display or DISP for vehicles with a drive monitor display). Turn the ignition off.
3. While pressing the Trip Meter reset button (Multi-Information Display) or while pressing the DISP button (for vehicles with a drive monitor display), press the “ENGINE START STOP” switch once (do not start engine) or turn the key in the ignition to run (one position before starting engine).
4. Continue to press and hold the button until the trip meter displays “000000”.
5 Turn the ignition off and then start the engine to verify the indicator has been reset.
When doing the oil change and topping up fluids you will need to use the following specifications:
Engine Size | 1.8L 4 Cyl. |
Motor Oil | OW-20 |
Oil Capacity w/Filter | 4.4 US qt. (4.2L) |
Brake/Clutch Fluid | SAE J1703 or FMVSS No.116 DOT 3 |
Engine Coolant | Toyota Super Long Life Coolant |
Manual Transmission | TOYOTA Genuine Manual Transmission Gear Oil LV |
CVT | Toyota Genuine CVTF FE |
Automatic Transmission | Toyota Genuine ATF WS |
You can cross reference the following Purolator filter numbers for your own application:
Engine Size | 1.8L 4 Cyl. |
Oil Filter | L16311 |
Air Filter | A25655 |
Cabin Filter | *Dealer Part |