1. Turn the ignition to run (one position before starting engine). 2. Press and release the SERVICE REMINDER button until the desired item is displayed. 3. When the desired item is displayed, do not release SERVICE REMINDER button. 4. After button has been pressed for approximately 10 seconds, the service interval mileage display will begin […]

1. Turn the ignition to run (one position before starting engine). 2. Press and release the SERVICE REMINDER button until the desired item is displayed. 3. When the desired item is displayed, do not release SERVICE REMINDER button. 4. After button has been pressed for approximately 10 seconds, the service interval mileage display will begin

1. Turn the ignition to run (one position before starting engine). 2. Press and release the SERVICE REMINDER button until the desired item is displayed. 3. When the desired item is displayed, do not release SERVICE REMINDER button. 4. After button has been pressed for approximately 10 seconds, the service interval mileage display will begin

1. Turn the ignition to run (one position before starting engine). The maintenance information (the wrench symbol and distance to change a maintenance item) comes on for about 5 seconds and then turns off. 2. Push the trip button and hold for 3 seconds while the wrench symbol and maintenance information are are displayed. The

1. Turn the ignition to run (push START/STOP button once). 2. Press the square) button, located on the instrument panel just behind the steering wheel to the left, to displaythe SETTINGS mode. 3. In the setting mode screen press the circle button to move to MAINTENANCE. 4. Set a desired interval by pushing the circle

1. Turn the ignition to run (push START/STOP button once). 2. Press the square) button, located on the instrument panel just behind the steering wheel to the left, to displaythe SETTINGS mode. 3. In the setting mode screen press the circle button to move to MAINTENANCE. 4. Set a desired interval by pushing the circle

1. Turn the ignition to run (push START/STOP button once). 2. Press the square) button, located on the instrument panel just behind the steering wheel to the left, to displaythe SETTINGS mode. 3. In the setting mode screen press the circle button to move to MAINTENANCE. 4. Set a desired interval by pushing the circle

1. Turn the ignition to run (push START/STOP button once). 2. Press the square) button, located on the instrument panel just behind the steering wheel to the left, to displaythe SETTINGS mode. 3. In the setting mode screen press the circle button to move to MAINTENANCE. 4. Set a desired interval by pushing the circle

1. Turn the ignition to run (push START/STOP button once). 2. Press the square) button, located on the instrument panel just behind the steering wheel to the left, to displaythe SETTINGS mode. 3. In the setting mode screen press the circle button to move to MAINTENANCE. 4. Set a desired interval by pushing the circle

1. Turn the ignition to run (one position before starting engine). 2. When you turn the ignition key run, the system start-up warning is displayed on the screen. Read the the warning and select the OK key by pressing the ENTER button. 3. When the TRIP button is pressed, the following modes will display on