To reset the 2004 Saturn Vue oil change light, please follow these instructions: 1. Turn the ignition to run (one position before starting engine). 2. Immediately after Step 1 press and release the gas pedal 3 times within 5 seconds. If the Change Engine Oil light is flashing, the system is reset. The light will […]
2004 Saturn Vue Oil Change Light Reset Read More »
To reset the 2014 Scion tC maintenance data you will need to follow these instructions: 1. Start the engine. 2. Select trip metre A reading by using the trip metre button and then turn the ignition off. 3. While pressing the trip meter reset button, turn the ignition switch to run (one position before starting
2014 Scion tC Maintenance Data Reset Read More »
To reset the 2013 Hyundai Santa Fe service interval, please follow these instructions to reset/setup: 1.Start the engine. 2. If a service is due the display will show “Service required”. To reset this message, press the SELECT/RESET button (left pointing arrow) on the bottom right of the steering wheel for more than 1 second. 3.
2013 Hyundai Santa Fe Service Interval Reset Read More »
The 2015 Toyota Corolla is equipped with the Toyota Maintenance Data System. After performing the oil change, the oil change indicator will need to be reset. The reset can be performed by following these instructions: 1. Press the “ENGINE START STOP” switch once (do not start engine) or turn ignition key to run (one position
2015 Toyota Corolla Oil Change Light Reset & Specifications Read More »
To replace the cabin air filter follow these steps: After removing the filter cover, remove the old cabin filter and take note of the the direction of the arrow on the cabin filter. Install the new cabin filter and ensure the arrow is pointing in the same direction. Work backwards to re-install the cabin filter.
2015 Toyota Corolla Cabin Air Filter Replacement Read More »
To reset the 2000 Honda Civic Maintenance Required light follow these instructions: 1. Reset the coloured indicator by inserting your key in the slot beside the indicator. http://www.oilreset.com
2000 Honda Civic Maintenance Required Light Reset Read More »
To reset the 2005 Lexus IS 250 or 350 oil change required light please follow these instructions: 1. Turn the ignition to run (one position before starting engine). 2. Bring up the odometer reading using the trip meter reset knob then the turn ignition off. 3. Hold down the trip meter reset knob while turning
2005 Lexus IS 250/350 Oil Change Required Light Reset Read More »
To reset the 2008 Jeep Commander’s Oil Change Required light, follow these instructions: 1. Turn the ignition to run (one position before starting engine). 2. Fully depress the accelerator pedal slowly three times within 10 seconds. 3. Turn the ignition off and then start the engine to verify the indicator has been reset.
2008 Jeep Commander Oil Change Required Light Reset Read More »
Follow these instructions to reset the Service Required light on the 2014 Kia Cadenza: 1. Start the engine. 2. If a service is due the display will show “Service required”. To reset this message, locate and press the DOWN button located at the bottom right of the steering wheel for more than 1 second. 3. The
2014 Kia Cadenza Service Required Light Read More »
Follow these instructions to reset the Maintenance Required light on the 2000 Honda Accord: 1. Turn off the engine. 2. Press and hold the SELECT/RESET button in the instrument panel. and turn the ignition switch ON (ii). 3. Hold the button for at least 10 seconds, until the indicator resets. 4. Turn the ignition off
2000 Honda Accord Maintenance Required Light Reset Read More »
