To reset the 2010 Jeep Wrangler, please follow these instructions: 1. Turn the ignition to run (one position before starting engine). 2. Fully depress the accelerator pedal slowly three times within 10 seconds. 3. Turn the ignition off and then start the engine to verify the indicator has been reset.

To reset the 2010 Infiniti G37, please follow these instructions: Turn the ignition on without starting the engine (press START/STOP) button. Monitor: 1. Push the INFO button and select MAINTENANCE. 2.  Select ENGINE OIL and then select RESET. 3. Press the BACK button. 4. Select OIL FILTER and then select RESET. 5. Press the BACK

To reset the 2011 Lexus ES350, please follow these instructions: 1. Turn the ignition to run (push START/STOP button once).  Use the trip meter switch to bring up the trip meter A reading.   Turn the ignition off. 2. While pressing the trip meter reset button, set the engine switch to run (push START/ STOP button

To reset the 2007 Nissan Altima maintenance info, please follow these instructions:   1. Turn the ignition to run (one position before starting engine/push START/STOP button once). 2. Press the square button (□) , located on the instrument panel just behind the steering wheel to the left, to display the SETTINGS mode. 3. In the

To reset the 2010 Mitsubishi Outlander Service Interval, please follow these instructions: 1. The “—” display can be reset while the ignition switch is “OFF”.  When the display is reset, the time until the next periodic inspection is displayed and “PERIODIC INSPECTION” is no longer displayed when the ignition is switched from “OFF” to “ON”.

To reset the 2008 Mercury Sable Oil Life, please follow these instructions: 1. Turn the ignition to run (one position before starting engine). 2. Press and release SETUP to display “OIL LIFE XXX% HOLD RESET = NEW”. 3. Press and hold RESET for 2 seconds and release to reset the oil life to 100%. 4.

To reset the 2007 Mercedes C Class Service light, please follow these instructions: 1. Turn the ignition to position 1 (one position before starting the engine). 2. Press the system selection button (3 located on the lower left of the steering wheel) repeatedly until the kilometer reading is shown in the multi information display.) 3.

To reset the 2006 Lincoln LS oil change light, please follow these instructions: 1. Turn the ignition to run (one position before starting engine). 2. Press the STATUS control to access the System Check function. 3. Press RESET to reset oil %. 4. Press and hold the RESET control to set to 100%.  After a

To reset the 2003 Honda Element Maintenance Required Light, please follow these instructions: 1. Turn off the engine. 2. Press and hold the SELECT/RESET button in the instrument panel and turn the ignition switch to run (one position before starting). 3. Hold the button for at least 10 seconds, until the indicator resets. 4. Turn