The 2014 Toyota Venza maintenance required light comes on when the vehicle is due or past due for an oil change service. After performing an oil change service, follow these instructions to reset the maintenance required light:
1. Start the engine and bring up the trip meter A reading.
Vehicles with smart key system:
2. Turn the “ENGINE START STOP” switch off.
3. While pressing the Trip Meter reset button, press the “ENGINE START STOP” switch once (do not start engine).
4. Continue to press and hold the button until the trip meter displays “000000”.
5. Turn the ignition off and then start the engine to verify the indicator has been reset.
Vehicles without smart key system:
2. Turn the ignition switch off.
3. While holding down the trip meter reset knob turn the ignition to run (one position before starting engine).
4. Hold down knob for at least 5 seconds. The odometer indicates “000000” and the light goes off. If the system fails to reset, the light will continue flashing.
5. Turn the ignition off and then start the engine to verify the indicator has been reset.
Filter Specification
The oil change on this vehicle is fairly straightforward with the oil pan and oil filter fairly accessible. The following FRAM filters are used on this vehicle:
Filter Type | Part # (2.7L) | Part # (3.5L) |
Oil Filter | 9972 | 9972 |
Air Filter | 10171 | 10169 |
Cabin Filter | 10285 | 10285 |
Oil Specification
The oil specs for this vehicle have been taken directly from the owner’s manual. More details around oil, torque, tires, and specifications can be referenced in the owner’s manual.