The 2014 Toyota Sienna maintenance light comes on when the vehicle is due or past due for an oil change service.  After completing the oil change, follow these instructions to reset the maintenance required light:

Vehicles without smart key system
1. Turn the ignition to run (one position before starting engine).
2. Ensure Trip Metre A reading is shown. Turn the ignition off.
3. While holding down the trip meter reset knob turn the ignition to run (one position before starting engine).
4. Hold down knob for at least 5 seconds. The odometer indicates “000000” and the light goes off. If the system fails to reset, the light will continue flashing.
5. Turn the ignition off and then start the engine to verify the indicator has been reset.

Vehicles with smart key system
1. Press the “ENGINE START STOP” switch once (do not start engine).
2. Ensure Trip Metre A reading is shown. Turn the ignition off.
3. While pressing the Trip Meter reset button, press the “ENGINE START STOP” switch once (do not start engine).
4. Continue to press and hold the button until the trip meter displays “000000” or if equipped the multi information display shows “COMPLETE”.
5. Turn the ignition off and then start the engine to verify the indicator has been reset.

Filter Specification

The oil change on this vehicle is fairly straightforward with the oil pan and oil filter fairly accessible. The following FRAM filters are used on this vehicle:

Oil Specification

The oil specs for this vehicle have been taken directly from the owner’s manual. More details around oil, torque, tires, and specifications can be referenced in the owner’s manual.