
The 2013 Toyota Matrix is offered in a gasoline model. After performing an oil change the maintenance data will need to be reset. Follow these steps to reset this light:
1. Press the “ENGINE START STOP” switch once (do not start engine) or turn ignition key to run (one position before starting engine).
2. Ensure Trip Meter A reading is shown. Turn the ignition off.
3. While pressing the Trip Meter reset button, press the “ENGINE START STOP” switch once (do not start engine) or turn ignition to run (one position before starting engine).
4. Continue to press and hold the button until the trip meter displays “000000”.
5. Turn the ignition off and then start the engine to verify the indicator has been reset.
When doing the oil change and topping up fluids you will need to use the following specifications:
Engine Size | 4 Cyl. 1.8L Gas | 4 Cyl. 2.4L Gas |
Motor Oil | 0W20 | OW20 |
Oil Capacity w/Filter | 4.4 US qt. (4.2L) | 4.0 US qt. (3.8L) |
Brake/Clutch Fluid | Dot 3 | Dot 3 |
Engine Coolant | Toyota Super Long Life Coolant | Toyota Super Long Life Coolant |
Manual Transmission | TOYOTA Genuine Manual TransmissionGear Oil LV or gear oil that meets API GL-4 and SAE 75W specifications | TOYOTA Genuine Manual TransmissionGear Oil LV or gear oil that meets API GL-4 and SAE 75W specifications |
Automatic Transmission | Toyota Genuine ATF WS | Toyota Genuine ATF WS |
Rear Differential | Hypoid gear oil API GL-5 | Hypoid gear oil API GL-5 |
Transfer Case | Hypoid gear oil API GL-5 | Hypoid gear oil API GL-5 |
You can cross reference the following Purolator filter numbers for your own application:
Engine Size | 4 Cyl. 1.8L Gas | 4 Cyl. 2.4L Gas |
Oil Filter | L16311 | L14677 |
Air Filter | A25655 | A45650 |
Cabin Filter | C25851 | C25851 |